- CAUTION -
WHEN ASSEMBLING A NEW OR REPAIRED TYRE, USE
AN ADAPTER FOR THE SPRING VALVE WITH A REMO-
TE GAUGE, WHICH ALLOWS THE OPERATOR TO STAY
WELL CLEAR OF THE TYRE WHILE IT IS BEING INFLA-
TED. USE A SAFETY CAGE.
- Do not inate any tyres over the pressure indicated by DIECI.
If the bead does not settle on the rim when this pressure
is reached, deate the tyre and lubricate again with a so-
lution of water and soap, then inate again. Do not use oil
or grease. Tyres inflated over the allowed pressure with
incorrectly set beads can cause the bead or rim to break
with an explosion strong enough to cause serious injury.
- PROHIBITION -
IT IS FORBIDDEN TO ASSEMBLE TYRES INFLATED
WITH POLYURETHANE FOAM UNLESS AUTHORISED
BY THE MANUFACTURER.
- Do not re-inate a tyre which has turned completely or
which is very at until it has been inspected by a quali-
ed technician.
- After reassembling the wheel, tighten the nuts between
the wheel and axle. Then check the nuts every day until
the torque has stabilised.
Replacing a wheel while on a public road
- If a wheel needs to be replaced on the edge of a road,
proceed as follows:
If possible, park the machine on flat and solid ground.
Engage the parking brake.
Stop the engine.
Switch on the hazard warning lights
Insert wedges under the wheels opposite the wheel to
change to ensure the machine is blocked in both directions.
Loosen the bolts on the wheel to change.
Place the jack under the axle half-box, as close as pos-
sible to the wheel.
Raise the wheel until it is off the ground; position the sa-
fety support under the axle.
Completely unscrew the wheel bolts and remove.
Push, pull and turn the wheel to extract it.
Insert a new wheel on the hub.
Tighten the bolts manually, lubricate with grease if ne-
cessary. Then tighten the bolts securely using a dyna-
mometric spanner.
Remove the safety support and lower the telehandler
with the jack.
Tighten the wheel bolts securely again using a dynamo-
metric spanner.
To Next Page
Loading...
