Assembly
38 Instructions for use Oxylog 3000 plus SW 1.n
Connecting the power supply
External power supply
To recharge the battery and to extend the operating
time, use one of the following:
– DC/DC converter, or
– AC/DC power pack.
For more information, refer to page 146.
Always position the device so that the external
power connector can be easily disconnected from
the ventilator.
WARNING
A fully charged battery must always be
installed for safety reasons, even when
operating from an external power supply.
WARNING
Risk of patient injury
Without a charged battery installed,
ventilation will be interrupted in case of an
external power supply failure.
Having a fully charged spare battery available
when using Oxylog 3000 plus is
recommended.
To Next Page
Loading...
Need help?
General
