Assembly
48 Instructions for use Oxylog 3000 plus SW 1.n
Connecting the CO2 sensor and the cuvette
1 Disconnect the angled connector (A)
from the flow sensor (D).
2 Attach the cuvette (C) to the flow sensor (D)
with the cuvette windows facing the side.
3 Attach the angled connector (A) to the
cuvette (C).
4 Push the CO
2 sensor (B) onto the cuvette (C),
with the cable towards the device.
5 Connect the CO
2 sensor to the port of
Oxylog 3000 plus. For the port location, refer to
the section "Side view, right" on page 19.
6 Insert the CO2 sensor cable in the cable clips on
the hose.
Alternatively, connect the cuvette (C) directly to the
patient side of the angled connector (A), without
disconnecting the angled connector from the flow
sensor (D).
After connecting the CO
2 sensor (mainstream
measurement, PGM algorithm, ambient pressure
compensation) or after a power supply failure, the
sensor must warm up for approx. 3 min before it is
ready for operation. During the warm-up phase and
at temperatures below 10 °C (50 °F), observe the
following:
–etCO
2 and CO2 values have a reduced
accuracy.
The CO
2 sensor cable can be extended with a
maximum of one extension cable. Refer to "List of
accessories" on page 163.
For information on CO
2 zero calibration and the
filter check before ventilation, see page 58. For
information on CO
2 zero calibration and the filter
check during ventilation, see page 91. For
information on CO
2 measurement and cuvette type
selection, see page 91. For information on CO
2
configuration in Customer Service Mode, see
page 103.
51
To Next Page
Loading...
Need help?
General
