MT
7.1.2 The PC-based Wizard program
The Wizard is a PC-based tool suited to programming
production runs of identical powerchairs or modules, or
one-off highly customised powerchairs.
7.1.2.1 Dongle versions
The Wizard requires a hardware security key (dongle) to
write parameters to a controller. Without dongle the
Wizard can still display parameter values and
diagnostic messages, but nothing can be edited or
written to a controller. The Wizard dongle is available in
several versions. The version of the dongle determines
the level of access to the powerchair parameters.
115
Dongle
level
Wizard Application
View Mode
OEM Advanced Used by the powerchair manufacturer.
Gives write access to a wide range of parameters.
Enhanced
Dealer
Standard Parameters that the powerchair manufacturer wants to
keep control of can be viewed, but not edited.
Parameters that relate to powerchair accessories (for
example actuators) can still be edited.
Dealer Lite A limited range of parameters can be viewed. Only a few
parameters can be edited. Parameters that may cause
hazards or require special expertise to set can not be
edited.
Factory Write Used in a factory setup to program production
powerchairs. No parameters can be edited. Only pre-
composed programs can be written to a controller.
Warning:
The Wizard is a very powerful tool and as such requires well trained
operators and a disciplined approach to usage and distribution.
It is up to the powerchair manufacturer to determine whether they will
allow distribution of Wizards to dealers.
To Next Page
Loading...
Need help?
General
