MT
10.5 Electromagnetic Compatibility (EMC)
Dynamic Electronic Controllers have been tested on typical vehicles to confirm
compliance with the following appropriate EMC standards:
USA: ANSI/RESNA WC/Vol:2 - 1998 Sec 21
Europe: EN12184: 1999 Sec 9.8.1-3
National and international directives require confirmation of compliance on particular
vehicles. Since EMC is dependant on a particular installation, each variation must be
tested. The guidelines in this section are written to assist with meeting EMC requirements.
10.6 Minimising emissions
To minimise emissions and to maximise the immunity to radiated fields and ESD, follow the
General wiring recommendations in section 2.1.1.
10.7 Environmental statement
This product has been supplied from an environmentally aware
manufacturer.
Please be environmentally responsible and recycle this product at
the end of its life through your local recycling facility.
This product may contain substances that could be harmful to the
environment if disposed of into a landfill.
143
To Next Page
Loading...
Need help?
General
