Dynamic DX User Manual

5.3.9.9 Power-up Profile Number
Parameter Possible Values Default Rev HHP Lite Std Adv
C

*
 
Power-up Profile Number 1 - 7 7
The Power-up Profile Number is the Profile in which the DX System will start when the
system is switched on. If Power-up Profile Number has the value '7', the DX System will
start up with the same Drive Profile that was active when the DX System was powered
down.
Single Profile
Power-up Profile Number is also used as the profile of choice when
Mode
GBK60348
: Issue 1 – October 2007
88
(see 5.3.10.4) is enabled.
Chair Speed Enable
*The HHP can edit this parameter when Single Profile Mode and
(see
5.3.10.3) are both set to 'Yes'. The chosen 'Response' is stored in the Power-up
Profile Number parameter.
RESPONSE
1
NEXT DOWN UP
The 'Response' chosen with the HHP is
stored in Power-up Profile Number
Note:
If Single Profile Mode is enabled, make sure to only use valid user
Drive Profiles for Power-up Profile Number (1 to the value of the
Maximum Profile Number parameter, see section 5.3.8.1).
5.3.9.10 Enable Joystick Wakeup
Parameter Possible Values Default Rev HHP Lite Std Adv
  
Enable Joystick Wakeup No / Yes Yes C -
Yes – The System wakes up when the joystick of the active Remote is deflected, or
when a switch or a button is pushed.
No – The System does not wake up when a joystick is deflected.
The System only wakes up when a button or a switch is pushed.
Set this parameter to 'No' to make sure that the system does not wake up when the
user accidentally deflects the joystick.
Enable Sleep Mode with the
Sleep Mode Enable parameter (see 5.3.9.8).

Dynamic DX Specifications

General

Brand	Dynamic
Model	DX
Category	Network Router
Language	English