MT
7.5 Retain the settings with a Master Remote replacement
The DX Master Remote stores a backup of all the programmable DX parameter
values. If the DX Master Remote is replaced, all the original parameter values are lost
because the new DX Master Remote will overwrite the original parameter values with
its own "backup" values (see
Auto Download
125
, 7.3).
To prevent the loss of the old parameter values, use the Wizard program to
• backup all the parameter values of the old Master Remote to the PC
• write the backup values from the PC to the new Master Remote.
Wizard reads and writes all the parameter values from and to the Master Remote,
even the values of the parameters that are not accessible with the dongle in use.
7.5.1 Replacement with the same type Master Remote
If the Master Remote is broken and it is replaced with exactly the same type Master
Remote, it is enough to read the values from the old Master Remote and to write
these values back to the new Master Remote.
1. Connect the old Master Remote to the PC and start up the Wizard
a) Connect the old Master Remote to the PC
b) Switch on the Master Remote
c) Start the Wizard
d) Read the conditions of use.
If you understand and
accept the conditions of use,
Click 'I Accept'
1d
e) Enter the dongle password, if required.
f) Wait until the status window
shows
• If the status window is still
empty after 30 seconds,
there is no connection between
the Master Remote and the PC.
The status window
To Next Page
Loading...
Need help?
General
