Dynamic DX User Manual

MT
67
5.3.7.5 Reverse Speed @ Maximum
Parameter Possible Values Default Rev HHP Lite Std Adv
Reverse Speed @ Maximum 10 – 100 % N/A -,A,C

  
Sets the reverse speed of the powerchair when the joystick is fully deflected
backward and the Speed Pot is in its Maximum position.
This parameter must be set for every Drive Profile.
See also section
5.3.2.3: Speed setting recommendations.
5.3.7.6 Reverse Speed @ Minimum
Parameter Possible Values Default Rev HHP Lite Std Adv
Reverse Speed @ Minimum 5 – 100 % 5% C

  
Sets the reverse speed of the powerchair when the joystick is fully deflected
backward and the Speed Pot is in its Minimum position.
This parameter must be set for every Drive Profile.
This parameter partially replaces the
Speed Pot Scaler parameter (see 5.3.9.5).
See also section
5.3.2.3: Speed setting recommendations.
5.3.7.7 Reverse Acceleration
Parameter Possible Values Default Rev HHP Lite Std Adv
Reverse Acceleration 10 – 70 % 70 % -,A,C

  
Sets the rate at which the reverse speed increases after the joystick has been
deflected backward. 10% results in a very slow increase, 70% results in a very quick
increase.
See also section
5.3.1.3 : Acceleration and deceleration.
5.3.7.8 Reverse Deceleration
Parameter Possible Values Default Rev HHP Lite Std Adv
Reverse Deceleration 15 – 100 % 30 % -,A,C

  
Sets the rate at which the reverse speed decreases after the joystick has been
returned to the centre. 15% results in a very slow stop, 100% results in an instant stop.
See also section
5.3.1.3 : Acceleration and deceleration.

Dynamic DX Specifications

General

Brand	Dynamic
Model	DX
Category	Network Router
Language	English