Dynamic DX User Manual

MT
Adjusting Veer compensation with the HHP
1. Turn the DX System ON
2. Connect the HHP to the DX Master Remote
41
3. Enter Technician Mode (see section
7.1.1.1: HHP Technician Mode)
4. Press NEXT 5. Press YES
Technician mode
Master JS Module
JOYSTICK CALIBRATION
EXIT YES NEXT
** MAIN MENU **
View or Edit Power
Module ? (Tech only)
NEXT YES
6. Press LEFT or RIGHT until the powerchair 7. Press EXIT to save the Veer
drives in a straight line when the Compensation value
joystick is deflected forward
8. Turn the DX System OFF
9. Disconnect the HHP
4.3.2.6 Emergency Deceleration
Parameter Possible Values Default Rev HHP Lite Std Adv
Emergency Deceleration 25 - 100 % 75 % -,A -
 

Emergency Deceleration sets the rate at which the powerchair comes to a halt when
• a fault that requires an emergency stop occurs
• the user switches off the system while driving.
If Emergency Deceleration is set to a higher value, the powerchair will stop in a
shorter time period. The optimum value depends on the powerchair type, the
preference of the manufacturer and the regulations that apply to the country of use.
Test this parameter by switching off the system while driving.
Warning:
The powerchair can tip over or throw the user out of the chair when
this parameter is set too high.
VIEW/EDIT POWER MOD
Veer compensation
RIGHT 0 %
EXIT NEXT LEFT RIGHT
VIEW/EDIT POWER MOD
Veer compensation
RIGHT 0 %
EXIT NEXT LEFT RIGHT

Dynamic DX Specifications

General

Brand	Dynamic
Model	DX
Category	Network Router
Language	English