Dynamic DX User Manual

MT
5.3.10.10 ACU Joystick Swap Left/Right
Parameter Possible Values Default Rev HHP Lite Std Adv
-,A,C

ACU Joystick Swap Left/Right No / Yes No -
 
Set ACU Joystick Swap Left/Right to 'Yes' if the Attendant Control Unit is mounted
• upside-down
• vertically to give forward driving when the joystick is deflected down.
This parameter only applies to the ACU. To apply Left/Right joystick swap to the RJM
joystick, use the
RJM Joystick Swap Left/Right
93
parameter (5.3.10.14). To apply
Left/Right joystick swap to the Master Remote joystick, use the
UCM Joystick Swap
Left/Right
parameter (5.3.10.7).
5.3.10.11 ACU has Momentary Switch
Parameter Possible Values Default Rev HHP Lite Std Adv
C

ACU has Momentary Switch No / Yes No -
 
The ACU has a switch to tell the Master Remote that it wants to take control of the
powerchair. This switch can be
• a latching switch (a switch that stays in the same position after switching), or
• a momentary switch (a switch that returns to its original position, for example a
push button).
If the ACU has a momentary switch, set ACU has Momentary Switch to 'Yes'.
Note:
The DX-ACU1 is fitted with a latching switch.
5.3.10.12 ACU Momentary Switch Timeout
Parameter Possible Values Default Rev HHP Lite Std Adv
ACU Momentary Switch
Timeout

 
No / Yes Yes C -
Yes – When the attendant has not operated the ACU for two minutes, the
DX System automatically switches from Attendant Mode to User Mode. This
allows the user to resume driving.
No – The DX System remains in the Attendant Mode until the Momentary Switch is
pushed to release the control of the powerchair back to the user.
If ACU has Momentary Switch (
5.3.10.11) is set to 'No', the value of ACU Momentary
Switch Timeout is ignored. Therefore, this parameter has no effect on the DX-ACU1.

Dynamic DX Specifications

General

Brand	Dynamic
Model	DX
Category	Network Router
Language	English