EasyManuals Logo

Dynamic DX User Manual

Dynamic DX
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #140 background imageLoading...
Page #140 background image
10.2 Maintenance
1. All vehicle components must be regularly checked for loose, damaged or corroded
connectors, terminals, or cabling. All cables must be restrained to protect them from
damage. Damaged components must be replaced.
2. All switchable functions on the Dynamic electronics system must be regularly tested
to make sure that they function correctly.
3. All Dynamic electronic components must be kept free of dust, dirt and liquids. If
necessary, wipe with a cloth dampened with warm water. Do not use solvents or
abrasive cleaners.
4. There are no user-serviceable parts in any Dynamic electronic component. Do not
attempt to open any case or undertake any repairs, or warranty will be voided.
5. Where any doubt exists, consult your nearest service centre or agent.
Warning:
If any component is damaged in any way, or if internal damage may
have occurred (for example by being dropped), have it checked by
qualified personnel before operating.
10.3 Warranty
All equipment supplied by Dynamic Controls is warranted by the company to be free from
faulty materials or workmanship. If any defect is found within the warranty period, the
company will repair the equipment, or at its discretion, replace the equipment without
charge for materials and labour.
This Warranty is subject to the provisions that the equipment:
has been thoroughly checked upon completion of installation, and all
programmable options correctly adjusted for safe operation prior to use.
has been correctly installed.
has been used solely in accordance with this manual and all other manuals of the
Dynamic electronic components that are used on the powerchair.
has been properly connected to a suitable power supply in accordance with this
manual.
has not been subjected to misuse or accident, or been modified or repaired by any
person other than personnel authorised by Dynamic Controls.
has been used solely for the driving of electrically powered wheelchairs in
accordance with the wheelchair manufacturer's recommendations.
GBK60348
: Issue 1 – October 2007
140

Table of Contents

Other manuals for Dynamic DX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynamic DX and is the answer not in the manual?

Dynamic DX Specifications

General IconGeneral
BrandDynamic
ModelDX
CategoryNetwork Router
LanguageEnglish

Related product manuals