Dynamic DX User Manual

• Make sure that the controller does not become colder or hotter than the minimum and
maximum temperatures specified in this manual.
• Most electronic equipment is influenced by Radio Frequency Interference (RFI). Be
careful when portable communications equipment is used in the area around such
equipment. Dynamic Controls has made every effort to make sure that RFI does not
change the behaviour of the controller, but very strong signals can still cause a
problem. The vehicle manufacturer has the responsibility to make sure that the vehicle
is tested according to local EMC regulations.
• Performance adjustments must only be made by healthcare professionals, or by
persons who completely understand the adjustment process and the capabilities of the
operator. Wrong settings, or programming in a location that is not safe, can cause injury
to the operator or bystanders, or damage to the vehicle or surrounding property.
• Performance adjustments must only be made indoors, or outdoors in dry conditions.
• After you have configured the vehicle, check to make sure that the vehicle performs to
the specifications entered in the programming procedure. If the vehicle does not
perform to specifications, reprogram it. Repeat this procedure until the vehicle performs
to specifications. If the wanted operation cannot be reached, contact your service
agent.
Service and Configuration Warnings
The following warnings are applicable to the installation technician and the dealer or the
therapist who supplies the vehicle to the end user.
• It is the responsibility of the installer to make sure that accessories that are connected
to the wires of the vehicle do not interfere with the operation of the controller.
• Make sure that the battery charger that is used with the vehicle has a drive inhibit
function that is correctly connected for use with the controller. If you are not sure, ask
your dealer or vehicle manufacturer.
• Do not use the vehicle frame as the earth return. Any electrical low-resistance
connection to the frame is a safety risk and is not allowed by international safety
standards.
• To make sure that the left motor and the right motor are not swapped, the motor
connectors must not be interchangeable. Keying or labelling of motors is therefore
recommended.
• If the vehicle loses electric power, it is important that an attendant is able to move the
vehicle easily.
• After you have completed the installation, check it thoroughly. Correctly adjust all
programmable options before the vehicle is used.
• The dealer, therapist or other agent who supplies the vehicle to the end user has the
responsibility to make sure that the vehicle is correctly configured for the needs of that
user. This must be confirmed by letting the user test-drive the vehicle in a safe area
together with their agent.
GBK60348
: Issue 1 – October 2007
142

Dynamic DX Specifications

General

Brand	Dynamic
Model	DX
Category	Network Router
Language	English