8-12 DynaVox Technologies
Chapter 8: Sound Management Creating Custom Recordings
4. Select the New button. The custom recording window will open.
5. The custom recording process will differ, depending on your
selection method:
• Touch Enter - Select and hold the Record button and speak
your message. When you are finished, release the Record
button.
• Touch Exit - Select the Start button and speak your message.
When you are finished, select the Stop button.
• Scanning - Activate the Record button and speak your
message. When you are finished, activate the Record button
again to stop recording.
• Mouse Pause - Move the mouse pointer onto the Record
button and speak your message. When you are finished, move
the mouse pointer off of the Record button.
6. If the Display Recording Feedback Window check box in the
Advanced Settings tab of the Interface Features menu is checked,
you will be asked what you want to do with the new recording.
Complete the rest of this step:
RECORDING FEEDBACK WINDOW
• Select the Playback button to review the recording.
• Select the Save button to save the recording and proceed to
step 5.
• Select the Record Again button to return to step 3 and record
the message again.
2 Note: If the Allow User to Name Recordings check box in the Advanced
Settings tab of the Interface Features menu is checked, the system
keyboard will open. Enter the name of the new sound and then
select OK.
2 Note: If the recording feedback menu does not appear, proceed to step 7.
To Next Page