9-2 DynaVox Technologies
Chapter 9: Environmental Controls Using Infrared Commands
USING INFRARED COMMANDS
You can program a button to activate an environmental control
command. When environmental control behaviors are programmed
into a button, you can simply select the button on the
MightyMo/MiniMo device to activate the behavior. Several of the
DynaVox Language Applications page sets include pages that
contain buttons with environmental control behaviors. The buttons on
these pages are already designed and organized an efficient layout.
You need only to add the specific codes for the appliance or computer
that you want to use.
X-10 commands and the commands for GEWA Jupiter and Tash
phones are pre-programmed according to the device that is being
used. You will need to refer to the documentation that came with your
X-10 system or your phone to know which command codes to select.
For infrared remote control, however, you must create your own
commands by using a remote control to teach commands to your
device.
Environmental Control
Pages in Supplied Page
Sets
The DynaVox Language Applications page sets include pages that
were designed to help you use a MightyMo/MiniMo device as an
environmental control unit (ECU). The following list includes the main
environmental control page for each page set. Some of these pages
can be used independently, and some contain Go To buttons that link
to other pages with environmental control buttons.
The buttons in these pages are intended to have Perform IR
behaviors. The labels and symbols in these buttons are
Page Set Environmental Control Page
12 Button Adult 12 Adult Television
Gateway 20 Adult GWA20 ECU
Preschool 9 computer (preschool)
9 email (preschool)
9 television (preschool)
Virtual 06 channels (virtual)
06 television (virtual)
To Next Page
Loading...