2-14 DynaVox Technologies
Chapter 2: Hardware Battery Information and Care
7. Charge your device until the charge light goes off.
8. Unplug the charger from your device.
9. Power your device on, making a note of the time.
10. Use your device for normal communications until it shuts down,
making a note of the time when it shuts down.
The time elapsed between steps 8 and 9 is the runtime of your device
battery.
Plug the Device In It is possible to extend the daily run time of the device’s battery pack
by using the DC adapter/charger that was shipped with your device. If
you are near an electrical outlet, you can use your MightyMo/MiniMo
while it is plugged in.
To use the charger while you are working with your MightyMo/MiniMo
device, follow these steps:
1. Connect the two pieces of the DC adapter/charger.
2. Plug the adapter into an electrical outlet.
3. Shut down your device.
4. Plug the charger jack into the charger port on the right side of your
device.
5. Turn the device back on.
Replace the MightyMo
Battery
If the battery in your MightyMo device becomes unable to maintain
power after being charged, it may need to be replaced. You can order
2 Note: It is best to charge your device overnight. Doing so will not damage
the battery or the device.
2 Note: Other ways to conserve battery power include using the backlight
timeout feature (see Setting the Backlight Timeout on page 5-41)
or adjusting the touch screen brightness (see Adjusting the
Screen Brightness on page 5-42).
To Next Page
Loading...