DynaVox MightyMo - Setting up the Perform IR X10 Command Behavior

MightyMo/MiniMo User’s Guide 9-7
Part # 400030-C
Using Infrared Commands Chapter 9: Environmental Controls
8. Select the appropriate IR command.
9. Select the OK button to close the Select IR Command menu. The
Steps list in the Behavior Editor menu will now contain the Perform
IR Command behavior with the name of the command in
parentheses.
10. Select the OK button to close the Behavior Editor menu.
11. Select the OK button to close the Modify Button menu.
Setting Up the Perform IR
X10 Command Behavior
Each appliance controlled by an X-10 module has its own unique
code, comprised of a number (1–16) and a letter (A–P). When a
button containing the Perform IR X10 Command behavior is selected,
the MightyMo/MiniMo sends an X-10 signal to control the appliance
named by the code in the command.
To add the Perform IR X10 Command behavior to a button, follow
these steps:
1. Open the page with the button that will contain the Perform IR X10
command.
2. Select the green Modify button in the title bar. The button will turn
red when it is selected.
3. Select the button that will contain the behavior. The Modify Button
menu will open.
2 Note: If the IR command you want to assign to the button does not exist
on your MightyMo/MiniMo device, follow the steps in Learning an
IR Signal on page 9-4 to create the IR command and assign it to a
button.
2 Note: Refer to the documentation that was supplied with your X-10
Command Center to learn the correct codes for the X-10
commands that you want to add to your MightyMo/MiniMo device.
2 Note: The required X-10 modules, Command Centers, appliances, etc.
must already be in place on the appliances and in the rooms where
the X-10 commands will be used.