10-6 DynaVox Technologies
Chapter 10: Using Custom Digital Pictures Transferring Pictures
To import a digital picture from a secondary storage card, follow these
steps:
1. Select the blue Setup button in the title bar. The Mo Setup menu
will open.
2. Select the Import Items button. The Import Items menu will open.
3. Select the Import Pictures button. The Select a Picture File menu
will open.
4. Select the Show All Directories check box.
5. In the left viewport, select the Storage Card2 folder.
6. In the right viewport, select the check box beside each picture file
you want to import. Or select the Select All check box to import all
of the pictures in the viewport.
7. Select the OK button. The Enter Label window will open with the
filename of the picture in the text box.
• To use the filename as the symbol name, select the OK button.
• To change the symbol name, select the text box and enter a
new name for the symbol. Select the OK button when finished.
8. Select the OK button when the image is imported successfully.
9. Select the OK button to close the Import Items menu.
10. Select the OK button to close the Mo Setup menu.
2 Note: Before you begin, be sure that the secondary storage card is
correctly installed in your device. If you have not yet done this, see
Install a Secondary Storage Card on page 2-18 before
proceeding with the steps below.
2 Note: These options will be presented for each picture that you are
importing. If you want to keep the symbol name the same as the
filename for all of the pictures that you are importing, select the
Stop Asking button in the Enter Label window.
2 Note: If there is not enough free space on your data storage card to
import the new file(s), an alert window will appear to inform you.
Select the OK button to close the window. In this case, you must
free space on your data storage card before importing the file(s).
To Next Page