ECKELMANN Case Controller UA 4 E Series - Page 137

Firmware V3.13
21.04.2021
137/466
10.Selectmenu3 Toggle Setpoint,inputoftherelevantparametersinthefollowingscreen:
3 Clock - 3 Toggle Setpoint
UMSCHALTNG POS: XXX
Status AUS Only visible if Sollumschaltg. is set to INT or EXT
Sollumschaltg. EXT Selection INT, EXT, --: internal, external, deactivated toggle setpoint
Selection
INT: internal
EXT: external
--: deactivated toggle setpoint
Laufzeit Rollo 0s Input operating time of the blind of the multidecks
Um EIN: DD-DD hh:mm Input time for toggle setpoint
(only visible if Sollumschaltg. is set to INT)
Um AUS: DD-DD hh:mm
Um EIN: DD-DD hh:mm
Um AUS: DD-DD hh:mm
11.TaptheESC button twice to exit the menu 3 Toggle Setpoint.