Ecotech Acoem Serinus 10 - Page 203

Parts List and Schematics
Page 203
59
Decimal Places
2 - 5
60
Noise
Instrument noise
61
Gas 1 Offset
An offset applied to Gas 1
62
Gas 3 Offset
An offset applied to Gas 3
63
Flow Temperature
Temperature of the flow block
64
Lamp Current
Lamp current in mA E.g 35mA
65
+5V Supply
Digital Supply voltage (should always read close to 5 volts)
66
Conc. Voltage
Concentration Voltage
67
High Voltage
High Voltage reading for PMT
68
Ozonator
0 = OFF, 1 = ON
69
Control Loop
0 = OFF, 1 = ON (default is ON)
70
Diagnostic Mode
0 = Operate
1 = Preamp
2 = Electrical
3 = Optical
(default is Operate)
71
Gas Flow
Units in slpm
72
Gas Pressure
Units in torr
73
Ambient Pressure
Units in torr
74
+12V Supply
The 12 volt Power supply voltage
75
Cell Temperature
Cell Temperature
76
Conv. Temperature
Converter Temperature
77
Chassis Temperature
Chassis Temperature
78
Manifold Temp.
Manifold Temperature
79
Cooler Temperature
Cooler Temperature
80
Mirror Temperature
Mirror Temperature
81
Lamp Temperature
Lamp Temperature
82
O3 Gen. Lamp Temp.
O3 Lamp Temperature
83
Instrument Status
Each bit in this 4-byte word represents a different condition
(not all conditions apply to every instrument model):
BIT
Condition if set
0
Currently in warmup process
1
Volumetric units (ppm); otherwise gravimetric units
(mg/m3)
2
Performing a background
3
Currently in Span mode
4
Currently in Zero mode