Ecotech Acoem Serinus 10 - Page 204

Serinus® 10 User Manual 3.2
Page 204
5
Instrument Out of Service (or in Diagnostic mode,
PTF compensation or control loop disabled, or
Comms debugging enabled)
6
High Voltage failure
7
System power failure (not actually possible to
report)
8
Reference voltage failure
9
Cell temperature failure
10
Cooler failure
11
Converter failure
12
Correlation wheel failure
13
Lamp source failure
14
Flow fault
15
Any system error (the red instrument panel light is
ON)
84
Reference Voltage
Units in Volts
85
Calibration State
This variable has two different sets of values:
Set Calibration State
0 = MEASURE
1 = CYCLE
2 = ZERO
3 = SPAN
Get IEEE Value
0 = MEASURE
1 = ZERO
2 = SPAN
86
Primary Raw Conc.
(For S40, before NOx background and gain)
87
Secondary Raw Conc.
Only for multigas instruments
(For S40, before NOx background and gain)
88
S40 Backgnd Conc.
NOx Background Concentration
(For S40, before gain)
89
Cal. Pressure
Calibration Pressure
90
Conv. Efficiency
Converter Efficiency
91
Multidrop Baud Rate
0 = 1200 bps
1 = 2400 bps
2 = 4800 bps
3 = 9600 bps
4 = 14400 bps
5 = 19200 bps
6 = 38400 bps
92
Anlg Range AO 0
Maximum range value for analog output
93
Anlg Range AO 1
94
Anlg Range AO 2