Endress+Hauser Proline Promass E 500 - Page 147

Proline Promass E 500 PROFIBUS PA Commissioning
Endress+Hauser 147
Unit totalizer
→  147
Totalizer operation mode
→  147
Control Totalizer 1 to n
→  147
Failure mode
→  147
Parameter overview with brief description
Parameter Description Selection Factory setting
Assign process variable Select process variable for totalizer. • Mass flow
• Volume flow
• Corrected volume flow
*
• Target mass flow
*
• Carrier mass flow
*
• Target volume flow
*
• Carrier volume flow
*
• Target corrected volume
flow
*
• Carrier corrected volume
flow
*
• GSV flow
*
• GSV flow alternative
*
• NSV flow
*
• NSV flow alternative
*
• S&W volume flow
*
• Oil mass flow
*
• Water mass flow
*
• Oil volume flow
*
• Water volume flow
*
• Oil corrected volume flow
*
• Water corrected volume
flow
*
–
Unit totalizer Select the unit for the process variable of the
totalizer.
Unit choose list Country-specific:
• kg
• lb
Control Totalizer 1 to n Control the totalizer value. • Totalize
• Reset + hold
• Preset + hold
–
Totalizer operation mode Select totalizer calculation mode. • Net flow total
• Forward flow total
• Reverse flow total
• Last valid value
–
Failure mode Define the totalizer behavior in the event of
a device alarm.
• Stop
• Actual value
• Last valid value
–
* Visibility depends on order options or device settings