Endress+Hauser Proline Promass E 500 - Page 172

Operation Proline Promass E 500 PROFIBUS PA
172 Endress+Hauser
Parameter Prerequisite Description User interface Factory setting
Water reference density For the following order code:
• "Application package", option
EJ "Petroleum"
• In the Petroleum mode
parameter, the Net oil &
water cut option is selected.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Signed floating-point
number
–
Oil density For the following order code:
• "Application package", option
EJ "Petroleum"
• In the Petroleum mode
parameter, the Net oil &
water cut option is selected.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the density of the oil
currently measured.
Signed floating-point
number
–
Water density For the following order code:
• "Application package", option
EJ "Petroleum"
• In the Petroleum mode
parameter, the Net oil &
water cut option is selected.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the density of the
water currently measured.
Signed floating-point
number
–
Water cut For the following order code:
• "Application package", option
EJ "Petroleum"
• In the Petroleum mode
parameter, the API
referenced correction
option is selected.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the percentage water
volume flow in relation to the
total volume flow of the fluid.
0 to 100 % –
Oil volume flow For the following order code:
• "Application package", option
EJ "Petroleum"
• In the Petroleum mode
parameter, the Net oil &
water cut option is selected.

The software options
currently enabled are
displayed in the
Software option
overview parameter.
Displays the currently
calculated volume flow of the
oil.
Dependency:
• Based on the value displayed
in the Water cut parameter
• The unit is taken from:
Volume flow unit
parameter
Signed floating-point
number
–