Epson Artisan 730 - Page 154

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
DISASSEMBLY/ASSEMBLY Disassembly Procedures 154
Confidential
3. Lift the CDR Tray Assy on the side with arms, remove the CDR Tray Assy to
the rear side of the printer.
Figure 4-100. Remove the CDR Tray Assy (2)
Rear side
CDR Tray Assy
Left arm
Right arm
Dowel on the right arm
Groove on the CDR Guide
 Make sure to insert the dowel of the right arm into the groove
on the CDR Guide. (See
Fig. 4-100.)
 Place the left arm over the right arm before installation. (See
Fig. 4-100.)
 If an arm comes off, place it to the CDR Tray at an angle as
shown in
Fig. 4-101, and insert the hook on the tray into the
hole of the arm, then rotate it in the direction of the arrow to
engage the arm to the tray.
Figure 4-101. Reassembling the CDR Tray Assy
 When installing the Spur Gear B, engage its teeth with the
grooves on the CDR Tray Assy. (See
Fig. 4-99.)
A D J U S T M E N T
R E Q U I R E D
 After replacing the CDR Tray Assy, make the specified
adjustments. (See
Chapter 5 "ADJUSTMENT".)
 When replacing the CDR Tray Assy, make sure to carry out
the specified lubrication. (See
Chapter 6 "MAINTENANCE" .)
Hole & hook
CDR Tray Assy