Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
DISASSEMBLY/ASSEMBLY Disassembly/reassembly procedures specific to Artisan 710/PX710W/TX710W 180
Confidential
7. Lift the Hinge on the right side in the direction of the arrow (1), and slide the
Scanner Unit in the direction of the arrow (2), and remove it.
Figure 4-158. Removing the Scanner Unit (3)
When installing the Scanner Unit, follow the procedure below.
1. Align and insert the dowel of the Scanner Unit to the hole of
the printer (Left inside).
2. Align and insert the rib of the Scanner Unit to the groove of
the Hinge.
Figure 4-159. Installing the Scanner Unit (1)
3. While aligning and inserting the rib of the Scanner Unit to
the groove of the Hinge, secure them with the screw (x1)
temporarily with the screw holes aligned as shown in
Fig.
4-157. It is recommended to prepare a pillow-shaped
supporter to keep this position. (See Fig. 4-11.)
(Continued to the next page.)
Rib of the Scanner Unit
& groove of the Hinge
Right
inside
To Next Page
Loading...
