Epson Artisan 730 - Page 221

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
ADJUSTMENT Adjustment Using Adjustment Program 221
Confidential
2. Select “Special Inspection”, and press LCD (Artisan 810/835/PX810FW/
TX810FW/PX820FWD/TX820FWD) or the “OK” button (Artisan 710/PX710W/
TX710W).
Figure 5-17. Case open sensor check (1)
3. Select “Sensor Check”, and press LCD (Artisan 810/835/PX810FW/TX810FW/
PX820FWD/TX820FWD) or the “OK” button (Artisan 710/PX710W/TX710W).
Figure 5-18. Case open sensor check (2)
4. Open the scanner and confirm the Cover open sensor condition changes to
“Open!”.
Figure 5-19. Case open sensor check (3)
C H E C K
P O I N T
 In the case of Artisan 810/835/PX810FW/TX810FW/
PX820FWD/TX820FWD, you can operate selection of each
menu, etc. by pressing the following areas on the touch panel
while in the special inspection mode.
Figure 5-16. Panel Operation in Special Inspection Mode
 The operation for the special inspection mode for Artisan 837/
PX830FWD differs from that for the others. See
"9.5.3 Special
Inspection Mode (p324) " for the details.
 In the case of Artisan 710/PX710W/TX710W, use the “Cross
Key and OK” button for menu selection.
“Power”
button
Left side of the touch panel
(Menu backward)
Right side of the touch panel
(Menu forward)
“CD/DVD tray” button
LCD (OK/Menu selection)
Inspection Mode
Run:OK / Select:[LEFT][RIGHT]
1. Mechanism Inspection
2. Special Inspection
3. Fax Inspection
4. Touch Screen Inspection
5. Development Mode
Special Inspection Mode
Run:OK / Select:[LEFT][RIGHT]
1. Inspection ALL
2. CSIC & IES Check
3. Panel Key Test
4. LCD/RGB & LED Test
5. Rom Ver. Check
6. USB Host Test
7. Sensor Check
Sensor Check
Cover open sensor condition
Open!
Photo Tray sensor condition
Open!
DUP unit sensor condition
Open!
After Check
Push [CDR Guide] Button