Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
ADJUSTMENT Adjustment Using Adjustment Program 222
Confidential
5. Place the thickness gauge 0.9mm on the location described in Figure 5-20.
Figure 5-20. Placement of the Thickness Gauge
6. Close the scanner and confirm the Cover open sensor condition changes to
“Closed!”.
Figure 5-21. Case open sensor check (4)
7. Open the scanner and replace the gauge to the thickness gauge 3 mm, and confirm
the Cover open sensor condition changes to “Open!” even when the scanner is
closed. (Refer to Figure 5-19.)
8. Press the “CD/DVD tray” button to return to the “Special Inspection” menu.
9. By pressing the “Power” button, turn off the printer to complete Check 1, and
perform Check 2 (p.223) continuously.
Front left
Place the gauge (0.9mm)
aligning it with the edge
of Upper Housing.
Sensor Check
Cover open sensor condition
Close!
Photo Tray sensor condition
Open!
DUP unit sensor condition
Open!
After Check
Push [CDR Guide] Button
If you confirm that the cover open sensor is not operating
correctly in
Step 4, Step 6, Step 7, check the connection of FFC
between the cover open sensor and the Main Board. If the
correct connection cannot improve the symptom, replace the
scanner unit with a new one.
Check 2 (p.223) is not necessary for Artisan 835/837/725/730/
PX820FWD/TX820FWD/PX830FWD/PX720WD/TX720WD/
PX730WD/TX730WD.
To Next Page
Loading...
