Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Revision G
ADJUSTMENT Adjustment without Using Adjustment Program 231
Confidential
• The EJ Frame Assy must be lowered most.
Figure 5-35. Position of EJ Frame Assy
• Check that the PG cams; located on both the left side and the right side of the
Carriage Shaft and the CR guide plate, are in the PG-position.
( Fig. 5-36 )
Figure 5-36. PG position when adjusting
Adjustment procedure
1. Move the carriage to the home position.
2. Loosen all the screws the secure each parallelism adjustment bushing. ( Fig. 5-34 )
3. Attach the parallelism adjustment jigs to the printer mechanism.
Figure 5-37. Installing the parallelism adjustment jigs
Confirm they are set here.
Place the rear of Jig on
Carriage Shaft.
A
B
C
D
Place the front of Jig on CR
Guide Plate.
C
D
Place Jig aligning the bits with the ribs shown above.
A
B
Place Jig aligning the bits with the ribs shown above.
Location of the bits of dial gauge (C) (D)
Location of the bits of dial gauge (A) (B)
To Next Page
Loading...
