Epson Artisan 730 - Page 265

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD Revision G
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD Disassembly/assembly 265
Confidential
6. Open the ADF Unit and insert the hook releasers (x2) fully as shown below
into the holes (x2) of the Scanner Upper Housing; where the hinges of the ADF
Unit are attached, to release the hooks (x2) of the Scanner Upper Housing.
Figure 8-5. Removing the ADF Unit (2)
7. With the hook releasers (x2) inserted, hold the center of the ADF Unit and
release the hooks (x2) of the hinges and hook (x1) of the ADF Cable Cover
from the rear side of the printer using a flathead screwdriver or the like. (See
Fig. 8-6.)
8. Remove the ADF Unit while pulling out the ADF Motor Cable, the ADF
Sensor Cable and the grounding wire from the hole of the Scanner Unit.
Figure 8-6. Removing the ADF Unit (3)
C H E C K
P O I N T
Make sure to insert the hook releaser into the hole of the Scanner
Upper Housing fully to release the hook.
If the hook releaser is not fully inserted into the hole, the hook
cannot be released because the releaser is blocked by the Hinge. (See
Fig. 8-5.)
Cross-section view of the hinge
Hook
Scanner Upper Housing
Hinge
Hook releaser
OK
NG
Insert the hook releaser fully
to release the hook.
If the hook releaser is not
fully inserted, the hook
cannot be released.
Hinges
ADF Unit
Hole of the Scanner Upper Housing
C A U T I O N
Take care not to let the cables get caught by the housing of the
Scanner Unit.
Hook
ADF Unit
Hole of the Scanner Unit
ADF Cable Cover
Cross-section view of the hinge
Hinge
Hook
Hook releaser