EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a Revision A
Troubleshooting Fax Troubleshooting 163
Confidential
Indications of destination number (in priority order)
NOTE 1 : Usually the destination fax ID signals (CSI/TSI/CIG) are registered with
numbers (telephone number is used in most cases). If these are registered
with text, the registered text are displayed as they are. When registering in
this product, select [Setup] → [General Settings] → [FAX Settings] →
[Basic Settings] → [Header] → [Your Phone Number] (number, space, or
+ only).
2 : For a product with Caller ID, the Destination fax ID is displayed when the
caller ID is enabled ([Fax settings] → [Basic settings] → [Caller ID
display]), and the sender notifies its telephone number. If the notified
telephone number has been registered in the contact list, the registered
name is displayed on the panel of the receiver. However, the telephone
number is used for fax log.
When a fax is sent without notification, the destination fax ID is
displayed.
3 : Usual settings are Sending/Polling Reception for sender, Receiving/
Polling sending for receiver. However if Manual send/Manual receive is
enabled, these settings may be reversed. In addition, if a fax is sent with
[Connected telephone] or [On hook dial] and Manual Send/Manual
Receive is turned on, the “destination fax ID” is always displayed.
Example)
(1)
Title Report name
PAGE
Number of pages to be reported
(number of pages/total number of pages)
Date /Time Printed time (yyyy.mm.dd hh:mm)
(2)
Name Sender’s name registered to the product
Fax Sender’s fax number registered to the product
(3)
Receipt No.
Job number
Common to other reports and job management.
This helps to identify the job.
Date / Time Starting time of communication
Type
Sending/Receiving/Polling Sending/Polling Reception/
PC Sending/Forwarding
ID See “Indications of destination number”
Duration mm:ss
Pages
Sending from memory: Number of pages of communication
succeeded/total number of pages
Direct sending/reception: Number of pages of communication
succeeded
Result
Succeeded: OK
Failed: Error details (Line Busy, No answer, Communication
Error
Line is not connected/Incorrect port connection/
Cancel, etc.)
Error xxx (Report Format = only when set to Detail)
Sender
(Send/Polling
Recive)(*3)
1. Registered name in the contact list
2. Dialed telephone number
3. Destination fax ID (*1)
Receiver
(Receive/Polling
Send)(*3)
1. Sender’s telephone number (when notifying number with the caller
ID)(*2)
2. Destination fax ID (*1)
Case Indications of destination number
When receive a fax through caller ID line,
then response with connected telephone
and perform Manual Send;
Sender is displayed. However, “sender’s
telephone number” is displayed other than
“destination fax ID”.
When send a fax with a connected
telephone and perform Manual Send;
Receiver is displayed. However, “destination
fax ID” is displayed other than the dialed
telephone number.
When send a fax with on hook dial
(Contact list/Direct dial)
Receiver is displayed. However,
“destination fax ID” is displayed other than
the registered name in the list or dialed
telephone number.
To Next Page
Loading...
Need help?
General
