EPSON WF-C5790/WF-C5790a/WF-C5710/ET-8700/WF-C5210/WF-C5290/WF-C5290a Revision A
Troubleshooting Fax Troubleshooting 200
Confidential
069 ---
070 BUSY TONE DETECT
On
Off
On
071 BT DET ON TIME MIN 5~65 40 x10ms
Minimum time to recognize busy tone signal on.
Shorter than this time does not judge it to be a busy tone.
072 BT DET ON TIME MAX 30~100 60 x10ms
Maximum time to recognize busy tone signal on.
Longer than this time does not judge it as a busy tone.
073 BT DET OFF TIME MIN 4~65 40 x10ms
Busy tone signal off confirmation time.
Upon detecting the busy tone signal off time longer than this setting, the
number of busy tone signals is counted as one.
074 BT DET OFF TIME MAX 30~100 60 x10ms
If the OFF time is longer than this, it is judged that the busy tone signal has
disappeared.
(Busy tone signal count is reset)
075 BT DET COUNT 2~4 4 times
076 ---
077 ---
078 ---
079 ---
080 TCF CHECK
Normal
Long
Normal
Level of judgment of line training.
If you make it long, more train the line situation. (It makes fall back easier)
081 CED-DIS INTERVAL
75ms
1sec
75ms
Set the signal interval time between the CED signal and the DIS signal
selected at incoming call.
To disable the echo suppressor overseas communication, set it to 1s.
082 REMOTE RX DET TIME 1~255 3 x10ms Adjust detection time of remote reception push signal.
083 ERROR LINE MODE
Rate
Line
Rate
Switching of error judgment mode of No-ECM reception.
Select number of error lines or error line rate.
Table 4-6. FAX Service Parameter Table
No. Parameter Name Setting Range Initial value Unit Remark
To Next Page
Loading...
Need help?
General
