Fiat TIPO 2016 - ELECTRIC WINDOWS; Switches, Diagrams, and Motor Connectors

All rights reserved. The circulation and reproduction of all or part of this guide by any means is prohibited.
FIAT TIPO -28- REV 0.0
Pinout
PIN
Function
1
Reference BCM GND for Left stack switch
2
High Side Driver (HS11) ( AD57-LF55-PH13) for IP dimming command
3
Negative signal (CAF+, CAF- commands) from IPC
4
not connected
5
GND (CAF+, CAF- commands) from IPC
6
not connected
7
Analog Input active to Vbat/Gnd for Rear / front fog lights signal (resistor code)
8
KL15 from F51 LSS supply
9
Positive signal for command ASR OFF
10
Positive command for TPMS reset
11
not connected
12
not connected
Electric windows.
The front and rear windows are managed by the Body Computer (BCM). Vehicle users can move the
windows using the switches on the door panels.
Two windows lifter versions are provided, low and high version.
Both versions have the same electrical architecture; the difference is related to the implemented
functionality.
LOW VERSION
For this version the following functionality is provided:
- on front windows, BCM manages always the automatic down movement. Up movement is
provided in automatic mode only on driver side, in manual mode on passenger side.
HIGH VERSION
This version provides four power windows lifter:
- on front windows, BCM manages always the automatic down movement. Up movement is
provided in automatic mode only on driver side, in manual mode on passenger side.
- on rear windows, windows lifter command provides only the manual up and down movement
of the window lifter motor.