Fiat TIPO 2016 - Covered Areas

All rights reserved. The circulation and reproduction of all or part of this guide by any means is prohibited.
FIAT TIPO -84- REV 0.0
PIN
Signal Description
A1
Ignition power
A2
n.c.
A3
n.c.
A4
n.c.
A5
n.c.
A6
CAN + HIGH
A7
System ground
A8
n.c.
A9
n.c.
A10
n.c.
A11
n.c.
A12
CAN - LOW
PIN
Signal Description
B1
Sensor (Rear right external)
B2
Sensor (Rear right internal)
B3
Sensor (Rear left internal)
B4
Rear sensor power feed
B5
Sensor (Rear left external)
B6
Trailer input
B7
n.c.
B8
Sensor ground
COVERED AREAS
Considering a car moving towards an obstacle, it is defined as FIRST APPROACH DISTANCE (1) the
distance at which the system starts producing intermittent signals, and as SECOND APPROACH
DISTANCE (2) the distance at which the signal becomes continuous.
The first approach distance has a minimum value of 150 cm ± 10 cm from the end of the vehicle body
and over the entire width of the latter (excluding the wing mirrors).
The second approach distance starts 30 ± 5 cm from the end of the vehicle body and must cover its
entire width (excluding the wing mirrors).