6100B/6105A
Users Manual
4-38
4-78. Remote Operation of the Energy Option
Remote commands are located in Chapter 5.
To start counting using the Energy Option, the energy-option status panel must be
displayed on the 6100B, if another wave-shape definition panel is shown, only the power
outputs will be activated, not the energy counter/timer. To guarantee correct operation it
is recommended that a command from the “ENERgy” tree is the last one sent before
“:OUTPut ON”; any command from this sub-system tree will re-display the energy status
screen.
Note
Some commands must be sent in a specific order and this is indicated when applicable.
To Next Page
Loading...
