Introduction
Features 1
1-5
XWWarning
To avoid electrical shock or personal injury, do not intentionally
or unintentionally interrupt the protective ground conductor
inside or outside the Instrument. Interrupting the protective
ground conductor is likely to make the Instrument dangerous.
Intentional interruption is prohibited.
1-6. Features
The Instruments feature the following:
• Traceable power and energy signals
• Configurable from one to four independent phases
• Full independent control of voltage and current on each phase
• 1 kV and 21 A available on each phase (50 A with the 50 A option, 80 A with the
80 A option) on each phase. By default, the N phase is limited to 33 V rms. This can
be overridden by the user. Setting up voltage and current waveforms are described in
later in this manual.
• Up to 100 harmonics and dc on either or both voltage and current channels.
• Fluctuating harmonics and interharmonics to IEC 61000-4-7 and 61000-4-13, 61000-
4-13 and 61000-4-14
• Dips and swells to IEC 61000-4-11
• Flicker to 61000-4-15
• Simultaneous power quality phenomena to IEC61000-4-30 and 61000-4-34
• Built-in IEC 61036 and IEC 62053 series current waveforms for static Watthour
meter testing.
• User-definable waveforms
• User-selectable reactive power calculation method
• >13 V peak compliance on all current outputs up to 21 A
• Soft start options to handle inrush current taken by instruments that take power from
the voltage signal
• Complex Instrument configurations can be saved to internal memory or to a USB
memory device for transfer to other 6105A0B systems
• The optional Energy Comparator provides for calibration of energy meters
• 10 MHz or 20 MHz reference clock output option
1-7. About this Manual
This manual provides complete information for installing the Electrical Power Standard
and operating it from the front panel and remotely. It also provides a glossary of terms as
well as detailed specifications. The following topics are covered in this manual:
• Installation
• Operating controls and features
• Front panel operation
• Remote operation (IEEE-488.2)
To Next Page
Loading...
