Fluke 6105A - Recall Event Status Enable; Read Event Status Register

6100B/6105A
Users Manual
5-62
the status byte.
Nrf is a Decimal Numeric Data Element representing an integer decimal value equivalent to
the Hex value required to enable the appropriate bits in this 8 bit register. The detailed
definition is contained in the IEEE 488.2 standard document. Note that numbers will be
rounded to an integer.
Execution Errors:
None.
Power On and Reset Conditions
Not applicable.
5-112. Recall Event Status Enable
This event status data structure conforms to the IEEE 488.2 standard requirements for this
structure.
Figure 5-5. Event Status Enable Query
Execution Errors:
None
Power On and Reset Conditions
The Power On condition depends on the condition stored by the common *PSC command if
0 then it is not cleared; if 1 then the register is cleared. Reset has no effect.
*ESE? recalls the enable mask for the standard defined events.
Response Decode:
The value returned, when converted to base 2 (binary), identifies the enabled bits which will
generate a summary message in the service request byte, for this data structure. The detailed
definition is contained in the IEEE 488.2 document.
5-113. Read Event Status Register
This event status data structure conforms to the IEEE 488.2 standard requirements for this
structure.
Figure 5-6. Event Status Register Query
*ESR? recalls the standard defined events.
Response Decode:
The value returned, when converted to base 2 (binary), identifies the bits as defined in the
IEEE 488.2 standard.
Execution Errors:
None