Fluke 6105A - Access to Edit Interharmonics; 6100 B Capability; Setting up Interharmonics; Fluctuating Harmonics

6100B/6105A
Users Manual
4-18
multiple of the frequency at which the system is operating (for example, if the
fundamental frequency is 60 Hz, an 83 Hz component in the waveform is an
interharmonic).
4-35. Access to Edit Interharmonics
Use  to navigate to the Waveform Menu and select the Edit Interharmonics
softkey. See Figure 4-19.
gdw60.bmp
Figure 4-19. Waveform Menu for Interharmonics
4-36. 6100B Capability
Maximum value of a single
interharmonic
The maximum value for an interharmonic <2850 Hz is 30 %
of range. (See Chapter 1 for the profile above 2850 Hz)
Frequency range of interharmonic 16 Hz to 9 kHz
4-37. Setting Up Interharmonics
Two interharmonic phenomena can be applied simultaneously.
Set the required amplitude and frequency of each and enable them with the check box.
Values entered outside the specified range result in an error message.
Use the Enable/Disable Waveshape softkey to turn this function on or off from the
Waveform Menu. Alternatively use the Enable/Disable Interharmonics softkey in
the Output Menu. See Figure 4-20.
gdw14.bmp
Figure 4-20. Softkeys for Interharmonics
4-38. Fluctuating Harmonics
The following sections explain the Fluctuating Harmonics Menus.