4-1
Chapter 4
Front-Panel Operation
Title Page
4-1.
Introduction............................................................................................. 4-3
4-2.
Power up ................................................................................................. 4-3
4-3. Warm up ................................................................................................. 4-3
4-4. Basic Setup Procedures........................................................................... 4-4
4-5. Global Settings........................................................................................ 4-5
4-6. Frequency ........................................................................................... 4-5
4-7. Line Locking ...................................................................................... 4-5
4-8. Harmonic Edit Mode .......................................................................... 4-5
4-9. Reactive Calculations ......................................................................... 4-6
4-10. Soft Start............................................................................................. 4-7
4-11. Units and Standards............................................................................ 4-7
4-12. Front-Panel Terminals........................................................................ 4-8
4-13. Rear-Panel Output Settings ................................................................ 4-9
4-14. More Settings ..................................................................................... 4-10
4-15. Voltage from Current Transfer Factors .............................................. 4-10
4-16. Save Setup and Load Setup Softkeys ................................................. 4-10
4-17. Set Date and Time .............................................................................. 4-11
4-18. GPIB Settings ..................................................................................... 4-11
4-19. Set Factory Defaults ........................................................................... 4-11
4-20. About .................................................................................................. 4-11
4-21. Edit Mode ............................................................................................... 4-11
4-22. Direct Mode........................................................................................ 4-11
4-23. Deferred Mode ................................................................................... 4-11
4-24. Changes that are not Deferred ............................................................ 4-11
4-25. Setting up Voltage and Current Waveforms........................................... 4-12
4-26. Harmonics, DC and Sine ........................................................................ 4-13
4-27. Definition............................................................................................ 4-13
4-28. Access to Edit Harmonics .................................................................. 4-13
4-29. 6100B Capability................................................................................ 4-13
4-30. Sine/Harmonic Mode.......................................................................... 4-13
4-31. Setting up Harmonics and DC............................................................ 4-15
4-32. Grid Edit Mode................................................................................... 4-16
4-33. Interharmonics ........................................................................................ 4-17
4-34. Definition............................................................................................ 4-17
4-35. Access to Edit Interharmonics............................................................ 4-18
4-36. 6100B Capability................................................................................ 4-18
4-37. Setting Up Interharmonics.................................................................. 4-18
4-38. Fluctuating Harmonics............................................................................ 4-18