6100B/6105A
Users Manual
6-6
To clean the air filter proceed as follows. See Figure 6-3:
1. Disconnect line power.
2. The air filter is accessible from the rear of the unit. If the unit is sited on a bench,
ensure that there is 24-inch clearance at the rear of the unit to allow you to withdraw
the filter.
3. Remove the filter by unscrewing the two knurled screws at the top and the bottom of
the vertical panel that secure the air filter. Pull the filter out of the unit.
4. Clean the filter by washing it in soapy water. Rinse and dry it thoroughly before
reinstalling.
5. Reinstall the filter and tighten the knurled screws.
TO CLEAN THE FILTER :
DISCONNECT POWER
REMOVE FILTER
FLUSH WITH SOAPY WATER
DRY BEFORE REINSTALLATION
gdw53.eps
Figure 6-3. Air Filter Access
To Next Page
Loading...
