Fluke 6105A - Page 5

Contents (continued)
iii
3-6. Using an External Keyboard and Mouse.......................................... 3-8
3-7. Sample Reference Signal and F10.................................................... 3-9
3-8. Set Up Exercise..................................................................................... 3-9
3-9. Switch to the Current Output............................................................ 3-10
3-10. Enable the Current Channel.............................................................. 3-10
3-11. The Current Channel is Enabled but Not Operating......................... 3-11
3-12. Set Up the L1 Current Channel ........................................................ 3-11
3-13. Over-Compliance Warning Message................................................ 3-12
3-14. Turn the Output Off.......................................................................... 3-13
3-15. Two-Wire / Four-Wire Voltage Settings .............................................. 3-13
3-16. Four-Wire Sense............................................................................... 3-14
3-17. Two-Wire / Four-Wire Configuration Settings ................................ 3-14
3-18. Rear-Panel Features .............................................................................. 3-16
4 Front-Panel Operation ........................................................................ 4-1
4-1. Introduction........................................................................................... 4-3
4-2. Power up ............................................................................................... 4-3
4-3. Warm up ............................................................................................... 4-3
4-4. Basic Setup Procedures......................................................................... 4-4
4-5. Global Settings...................................................................................... 4-5
4-6. Frequency ......................................................................................... 4-5
4-7. Line Locking .................................................................................... 4-5
4-8. Harmonic Edit Mode ........................................................................ 4-5
4-9. Reactive Calculations ....................................................................... 4-6
4-10. Soft Start........................................................................................... 4-7
4-11. Units and Standards.......................................................................... 4-7
4-12. Front-Panel Terminals...................................................................... 4-8
4-13. Rear-Panel Output Settings .............................................................. 4-9
4-14. More Settings ................................................................................... 4-10
4-15. Voltage from Current Transfer Factors ............................................ 4-10
4-16. Save Setup and Load Setup Softkeys ............................................... 4-10
4-17. Set Date and Time ............................................................................ 4-11
4-18. GPIB Settings ................................................................................... 4-11
4-19. Set Factory Defaults ......................................................................... 4-11
4-20. About ................................................................................................ 4-11
4-21. Edit Mode ............................................................................................. 4-11
4-22. Direct Mode...................................................................................... 4-11
4-23. Deferred Mode ................................................................................. 4-11
4-24. Changes that are not Deferred .......................................................... 4-11
4-25. Setting up Voltage and Current Waveforms......................................... 4-12
4-26. Harmonics, DC and Sine ...................................................................... 4-13
4-27. Definition.......................................................................................... 4-13
4-28. Access to Edit Harmonics ................................................................ 4-13
4-29. 6100B Capability.............................................................................. 4-13
4-30. Sine/Harmonic Mode........................................................................ 4-13
4-31. Setting up Harmonics and DC.......................................................... 4-15
4-32. Grid Edit Mode................................................................................. 4-16
4-33. Interharmonics ...................................................................................... 4-17
4-34. Definition.......................................................................................... 4-17
4-35. Access to Edit Interharmonics.......................................................... 4-18
4-36. 6100B Capability.............................................................................. 4-18
4-37. Setting Up Interharmonics................................................................ 4-18
4-38. Fluctuating Harmonics.......................................................................... 4-18
4-39. Definition.......................................................................................... 4-19
4-40. Access to Fluctuating Harmonics..................................................... 4-19