Need help?Do you have a question about the FoxGate S6424-S2C2 series and is the answer not in the manual?
General| Series | S6424-S2C2 series |
|---|---|
| Category | Switch |
| Switching Capacity | 56 Gbps |
| Power Supply | AC 100-240V, 50/60 Hz |
| Storage Temperature | -40°C to 70°C |
| MAC Address Table | 16K |
| Jumbo Frame Support | 9K bytes |
| Humidity | 5% to 95% non-condensing |
| Dimensions | 440 x 44 mm |
| Forwarding Rate | 41.7 Mpps |
Establishes switch connection and initial configuration using a console port.
Procedures for adding, changing, and deleting users, and managing privilege levels locally.
Comprehensive guide to configuring basic Ethernet port settings like mode, speed, duplex, and VLAN.
Detailed steps for configuring static and dynamic LACP aggregation groups for port bundling.
Configuration steps for dynamic LACP aggregation groups, including system and port priority settings.
Procedure to add ports to an isolation group, restricting communication between isolated members.
Procedure for creating, modifying, and managing VLANs, including adding ports to VLANs.
Security measures against ARP spoofing attacks, including anti-spoofing protection.
Security features like limiting client numbers and configuring IP-Source-Guard for enhanced network protection.
Steps to define extended ACLs, filtering based on IP addresses, protocols, ports, and other L3/L4 information.
Configuration of Layer 2 ACLs for packet classification based on MAC addresses, VLAN IDs, and Layer 2 protocol fields.
Process of activating configured ACLs to enforce filtering rules on network traffic.
Configuration of QoS features like flow monitors, traffic shaping, priority mapping, and queue scheduling.
Configuration steps for Rapid Spanning Tree Protocol (RSTP) to optimize convergence time and network stability.
Steps for configuring EAP, enabling 802.1X, port parameters, re-authentication, and watch features.
Comprehensive guide to configuring MSTP, including timers, identifiers, bridge priority, and port settings.
Using Ping and Tracert commands to test network connectivity and diagnose network issues.
Configuration of Flex Links groups, including master/slave ports, preemption modes, and delay settings.
To Next Page
