Command Line Interface
Nonprinting characters, such as passwords or tabs, are in angle brackets (< >).
2.7 Parameter in Command
There are 5 types of parameters:
Integer
The two numbers in the angle brackets (<>), connecting by hyphen (-) mean this
parameter is the integer between these two numbers.
For example: INTEGER<1-10> means user can key in any integer which can be more than
or equal to 1 and less than or equal to 10, such as 8.
IP address
A.B.C.D means an IP address.
For example: 192.168.0.100 is a valid IP address.
MAC address
H:H:H:H:H:H means a MAC address. If a multicast MAC address is needed, there would
be corresponded prompt.
For example: 01:02:03:04:05:06 is a valid MAC address.
Interface list
Interface list is prompt as STRING<3-4>. Port parameter interface-num consists of port
type and port number. Port type is Ethernet and port number is device/slot-num/port-num.
Device means stack value which is 0; slot-num means slot number (S6424-S2C2 supports
slot 0 and 1 and S6424-S2C2 supports slot 0, 1 and 2); port-num is the port number in the slot
(S6424-S2C2 is in the range of 1 to 24 and S6424-S2C2 is in the range of 1 to 48). Port
parameter interface-list means multiple ports. Seriate interfaces with the same type can be
linked by “to”, but the port number behind the “to” must be larger than the one in the front, and
this argument only can be repeated up to 3 times. The special declaration of interface
parameter interface list will be displayed in the command.
For example: Showing spanning-tree interface ethernet 0/0/1 ethernet 0/0/3 to ethernet
0/0/5 means showing the spanning-tree information about interface ethernet 0/0/1, ethernet
0/0/2, ethernet 0/0/3, ethernet 0/0/4 and ethernet 0/0/5.
String
The prompt STRING<1-19> means a character string which is in the length of1 to 19.
Enter “?” to see the parameter description of this command.
To Next Page
Loading...
Need help?
General
