FoxGate S6424-S2C2 series User Manual

Configuring MSTP
190
Note: mcheck function is a prerequisite for the port must send BPDU packets, so only
works on the specified port.
23.4.13 Configuring MSTP Instance Is Enabled
In order to flexibly control MSTP, you can open the DISABLE INSTANCE features, disable
instance STP mode operating results with the implementation of no spanning-tree similar to
the instance of the VLAN mapping of all connections on port forwarding state.
Table 23-13 Configuring MSTP instance is enabled
Operation
Command
Remark
Enter global
configuration mode
configure terminal
-
Does not enable
MSTP instance
spanning-tree mst disable instance instance-number
Optional
Enable MSTP
instances
no spanning-tree
23.4.14 Displaying and Maintain MSTP
After completing the above configuration, can use the following command to view
configuration. RSTP
Table 23-14 Display MSTP and maintain
Operation
Command
Remarks
MSTP configuration information
display identifier
show spanning-tree mst config-id
Performs
either of the
commands
Show spanning tree instance and
port configuration information
show spanning-tree mst instance
instance-num interface [ interface-list]

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English