FoxGate S6424-S2C2 series User Manual

Monitor Link Configuration
249
group if role preemption is configured in the Flex link group on Switch A.
Collaboratively, Monitor Link and Flex Link deliver reliable link redundancy and fast
convergence for dual-uplink networks.
33.3 Configuring Monitor Link
33.3.1 Monitor Link Configuration Tasks
Table 33-1 Flex Links Configuration Tasks
Operation
Remarks
Related
sections
Monitor Link
configuration
For channel-group
Required
For port
Required
Monitor Link monitor and maintainenance
Optional
33.3.2 Configure Monitor Links Group
If the port is Ethernet port, configuration should be in interface configuration mode; if port
is channel-group member, configuration should be in global configuration mode.
Table 33-2 Configure Monitor Links group
Operation
Command
Remarks
Enter global
configuration mode
configure terminal
-
Monitor Link for
channel-group
channel-group channel-group-number
monitor-link-group group-ID { uplink | downlink }
-
Delete channel-group
from Monitor Link group
No channel-group channel-group-number
monitor-link-group group-ID { uplink | downlink }
Optional
Enter interface
configuration mode
interface ethernet device/slot/port
-
Monitor Link for port
switchport monitor-link-group group-ID { uplink |
downlink }
-
Delete port from Monitor
Link group
No switchport monitor-link-group group-ID
{ uplink | downlink }
Optional
33.3.3 Monitor Link Monitor and Maintenance
After finishing above configuration, user can check the configurations by command below.
Table 33-3 Monitor Link monitor and maintenance
Operation
Command
Remarks
Show Monitor Link group
show monitor-link-group
On any configuration
mode

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English