FoxGate S6424-S2C2 series User Manual

L2TP Configuration
267
36.2.2 Advanced L2TP Configuration
By default, L2TP will be up to CPU. This command will configure the rate for up to cpu.
Table 36-2 Advanced L2TP configuration
Operation
Command
Remarks
Enter global configuration
mode
configure terminal
-
Configure the rate for up to
cpu
l2-tunnel drop-threshold [ cdp| lacp|
pagp| stp| udld| vtp] rate
Optional
36.2.3 L2TP Monitor and Maintenance
After finishing above configuration, user can check the configurations by command below.
Table 36-3 L2TP monitor and maintenance
Operation
Command
Remarks
Show L2TP configuration
show l2-tunnel interface [ethernet
interface-num]
On any
configuration
mode
Show the rate for up to cpu
show l2-tunnel drop-threshold
On any
configuration
mode

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English