Mac Address Authentication Configuration
Default mode for the mac address.
When using a radius server for authentication, there are two authentication methods can
be used for selection: 1) pap; 2) chap.
Radus default authentication mode for the pap.
AAA Authentication Domain, RADIUS server and the local user database configuration
information 802.1x configuration related content.
The following only shows the Mac address authentication module to perform the
command.
Table 35-1 Configure AAA Authentication Domain option
Enter global configuration
mode
Choice AAA Authentication
Domain
mac-authentication domain <name>
Configure user name
format
mac-authentication user-name-format {fixed
account <name> password <psw>} |
mac-address
Configure radius
authentication
mac-authentication encryption {pap | chap}
35.2.2 Enabling Configuration
Related parameters, it needs to start before they can be the mac address authentication.
Need to start the global mode and port mode mac authentication, the port of mac
authentication before they can take effect.
Table 35-2 Enabling configuration
Enter global configuration
mode
Enable Global
Configuration
Enter port configuration
mode
interface ethernet device / slot / port
Enable the Port
Configuration
35.2.3 Off Assembly Line Testing Configuration
As the mac does not use authentication protocol packets to interact, it can not take the
initiative off the assembly line Operation, the system detects the user through the user packet
flow off the assembly line judge.Mac authenticated users to go online, then start off the
assembly line detection timer when the timer reaches the user traffic after the detection if
To Next Page
Loading...
Need help?
General
