FoxGate S6424-S2C2 series User Manual

Configuring MSTP
184
configuration
Configure bridge max aging time
optional
23.4.3
Configure bridge max hops
optional
23.4.3
Configure MSTP identifier
optional
23.4.4
Configure MSTP identifier revision
optional
23.4.4
Configure MSTP instance configuration
and VLAN identifier mapping
optional
23.4.4
Configure MSTP bridge priority
optional
23.4.5
Configure the boundary port status
optional
23.4.6
Configure the port link type
optional
23.4.7
Configure port internal path cost
optional
23.4.8
Configure port external path cost
optional
23.4.8
Configure port priority
optional
23.4.9
Configure port protection
optional
23.4.10
Configure port digest Snooping
optional
23.4.11
Configure port mCheck
optional
23.4.12
Configure MSTP instance is enabled
optional
23.4.13
Display and maintain MSTP
optional
23.4.14
23.4.2 Enabling MSTP
After the tree starts to give birth to a global default for all ports will participate in the
spanning tree topology is calculated, if an administrator wants some of the port does not
participate in the calculation of the production tree, or go to the specified port configuration
mode, use the no spanning-tree to disable the port Spanning Tree function.
Table 23-2 Enable MSTP
Operation
Command
Remark
Enter global
configuration mode
configure terminal
-
Choice STP mode
spanning-tree mode mstp
required
Enable STP
spanning-tree
required
Enter port
configuration mode
interface ethernet interface-num
-
Enable(disable) port
STP
(no)spanning-tree
optional
23.4.3 Configuring MSTP Timer Parameter Values
MSTP timers include: forwarding delay, contracting cycle hello time, maximum aging time,
and the maximum hops. Users can configure these three parameters on the switch for MSTP
spanning tree.

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English