FoxGate S6424-S2C2 series User Manual

QoS Configuration
139
Table 20-16 Configure flow statistic
Operation
Command
remark
Enter globally configuration
mode
configure terminal
-
Configure flow staticstic
traffic-statistic { [ ip-group { num |
name } [ subitem subitem ] ]
[ link-group { num | name }
[ subitem subitem ] ] }
optional
reset to Zero
clear traffic-statistic { [ all |
[ ip-group { num | name } [ subitem
subitem ] ] [ link-group { num |
name } [ subitem subitem ] ] ] }
optional
20.2.11 Configuring Flow Mirror
Flow mirror is copying the service flow which matches ACL rules to specified monitor
interface to analyze and monitor packet.
20.2.12 Displaying and Maintain QoS
After finishing above configuration, please use below commands to show the
configuration.
Table 20-17 Display and maintain QoS
Operation
Command
remark
Display all the informaion of QoS
show qos-info all
perform
either of the
commands
Display QoS statistic
show qos-info statistic
Display quue-scheduler mode and
parameters
show queue-scheduler
Display the cos-map relationship of
hardware priority queue and priority of
IEEE802.1p protocol
show queue-scheduler cos-map
Display the dscp-map relationship of
hardware priority queue and priority of
IEEE802.1p protocol
show queue-scheduler dscp-map
Display all QoS port configuration
show qos-interface [interface-num ] all
Display rate-limit parameters
show qos-interface [interface-num ]
rate-limit
Display interface line rate parameters
show bandwidth-control interface
Ethernet [interface-num]
Display QoS interface statistic
parameters
show qos-interface statistic
Display traffic-priority parameters
show qos-info traffic-priority
Display traffic-redirect parameters
show qos-info traffic-redirect
Display packet redirection
show qos-info traffic-statistic
Display information of traffic copy to CPU
show qos-info traffic-copy-to-cpu

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English