FoxGate S6424-S2C2 series User Manual

Configuring 802.1X
167
Table 22-6 Enable 802.1x
Operation
Command
Remark
Enter global configuration mode
configure terminal
-
Enable 802.1x
dot1x method { macbased | portbased }
required
22.3.3 Configuring 802.1x Parameters for Port
The 802.1x proxy detection function depends on the online user handshake function. Be
sure to enable handshake before enabling proxy detection and to disable proxy detection
before disabling handshake.
Table 22-7 Configure 802.1x parameters for a port
Operation
Command
Remark
Enter global configuration mode
configure terminal
-
Configure 802.1x parameters for a port
dot1x port-control { auto | forceauthorized |
forceunauthorized } [ interface-list ]
required
22.3.4 Configuring Re-authentication
In EAP-FINISH way, the port supports re-authentication. After the user is authenticated,
the port can be configured to immediately re-certification, or periodic re-certification.
Table 22-8 Configure re-authentication
operation
Command
Remarks
Enter global configuration
mode
configure terminal
-
Immediately
re-certification
dot1x re-authenticate [interface-list]
Optional
Periodic re-authentication
enabled on a port
dot1x re-authentication [interface-list]
Optional
Periodic re-authentication
time configuration port
dot1x timeout re-authperiod time [interface-list]
Optional
22.3.5 Configuring Watch Feature
Opening function, the port without the user's circumstances, will watch regularly sends a
1x packet, triggering the following 802.1x user authentication.
Table 22-9 Configure watch feature
Operation
Command
Remarks
Enter global configuration
mode
configure terminal
-
Open the watch function
dot1x daemon [interface-list]
Optional
Configuration time
between sending packets
Watch
dot1x daemon time time [interface-list]
Optional

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English