FoxGate S6424-S2C2 series User Manual

Flex Links Configuration
245
preemption delay
{ interface device/slot/port_2 |
channel-group
channel-group-number_2 }
preemption mode <1-60>
port_2/channel-group-number_2
is slave port
32.2.5 Configure Flex links MMU
MMU messages are used by a Flex link group to notify other switches to refresh their MAC
address forwarding entries and ARP/ND entries when link switchover occurs in the Flex link
group. MMU messages are common unicast data packets, and will be dropped by a blocked
receiving port. This function is disabled by default.
Table 32-5 Configure Flex links MMU
Operation
Command
Remarks
Enter global
configuration mode
configure terminal
-
Configure Flex links
MMU
mac-address-table move
update { transmit | receive }
port_1 is master port，
port_2/channel-group-number_2 is
slave port
32.2.6 Flex Links Monitor and Maintenance
After finishing above configuration, user can check the configurations by command below.
Table 32-6 Flex Links monitor and maintenance
Operation
Command
Remarks
Display configured Flex Links
group
show interface switch backup
On any
configuration
mode
Display Flex Links MMU status
sh mac-address-table move update
On any
configuration
mode

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English