FoxGate S6424-S2C2 series User Manual

QoS Configuration
135
packet or reconfigure their priority.
Table 20-5 Configure flow rate
Operation
Command
remark
Enter globally
configuration mode
configure terminal
-
Enter port configuration
mode
interface ethernet device/slot/port
optional, perform
either of the
globally and port
mode
Configure flow rate
rate-limit { input | output } { [ ip-group { num |
name } [ subitem subitem ] ] [ link-group { num |
name } [ subitem subitem ] ] } target-rate
optional
20.2.2 Configure Two Rate Three Color Marker
Two Rate Three Color Marker is defined in RFC 2698. There is 4 parameter for it: CIR,
CBS, PIR and PBS.
Table 20-6 Configure Two Rate Three Color Marker
Operation
Command
remark
Enter globally
configuration mode
configure terminal
-
Configure Two Rate Three
Color Marker
two-rate-policer policer-id cir cir cbs cbs pir
pir pbs pbs [ color-aware ] [ drop-red ]
optional
Enter port configuration
mode
interface ethernet device/slot/port
optional, perform
either of the globally
and port mode
Configure Two Rate Three
Color Marker
rate-limit { input | output } { [ ip-group { num |
name } [ subitem subitem ] ] [ link-group
{ num | name } [ subitem subitem ] ] }
two-rate-policer policer-id
optional
20.2.3 Configuring Interface Line Rate
Line-limit is the speed limit based on interface which restricts the total speed of packet
outputting.
Table 20-7 Configure interface line rate
Operation
Command
remark
Enter globally configuration
mode
configure terminal
-
Enter port configuration mode
interface ethernet device/slot/port
-
Configure egress rate
bandwidth-control egress target-rate
optional
Configure ingress rate
bandwidth-control ingress target-rate
optional

FoxGate S6424-S2C2 series Specifications

General

Brand	FoxGate
Model	S6424-S2C2 series
Category	Switch
Language	English